| Specifications: | |
|
|
|
|
Width: |
36 inch |
|
Length: |
50ft rolls, Custom lengths up to 50
continuous feet are available upon request. |
|
Thickness: |
3mm or 0.12 inches (just under 1/8 inch) |
|
Weight: |
0.9 lbs per square foot |
|
Hardness: |
60 Shore A Nominal |
|
Compression: |
36% @ 50 PSI |
|
Tensile Strength: |
600 PSI |
|
Available Colors: |
Black |
|
Applications: |
Access Ramps, Alleys, Boats, Boat Ramps,
Churches, Car Restoration, Docks, Duckboards, Entryways, Factory Ramps,
Fitness Centers, Hospital Ramps, Hotel Ramps, Inclines, Loading Docks,
Office Buildings, Outdoor Walkways, Ramps, School Facilities, Slopes,
Superior Anti-Slip Surface, Walkways, Wet Areas, Wheel Chair
Accessibility. |
|
Excellent Traction: |
The Ramp Cleat offers the ultimate traction
through cleat protrusions, which run the width of the roll. This rubber
runner is one of few runner products that offers deep studded barrier
for additional toehold when going up inclines or across moist surfaces.
The angular corrugations also help remove excess soil from feet when
used as an entry scraper mat. |
|
Permanent Installations: |
For most high traffic applications, the Ramp
Cleat runner must be permanently installed with a polyurethane based
adhesive (such as Chemrex® CX-941). |
|
Temporary Installations: |
For temporary indoor or outdoor
installations, the Ramp Cleat rubber runner can be installed with Orcon
DS-PS, a double sided sealing tape. By adhering the perimeter of
the mat, the semi-permanent 2-sided tape secures the roll for use and
allows the flooring to be removed when needed. |
|
Custom Cuts: |
The Ramp-Cleat can be purchased in any
length, up to 50 continuous feet, in half-foot increments. Being a
sheet good, it can be custom die, laser, or water -jet cut to match any
dimension or size required. It could also be easily cut using a
sharp utility knife on location, to meet any dimensional requirement. |
|
Cleaning: |
Since this product offers moderate chemical
resistance, it can be cleaned with most common household cleaners.
Strong, highly caustic cleaning solutions are not recommended. For
interior applications, mopping the product is ideal. Exterior, a water
hose or broom is the preferred cleaning method. |
